Johnson C7000 - Page 37

idler assembly.
new one.
Reverse step 1-7 to install the parts.
BEARING REPLACEMENT PROCEDURE
Tools required:
Philips screwdriver
 Hex key (4mm)
 Bearing puller
 C-Clip pliers
Wooden hammer
ch
Crank extractor
rocedure:
5.
s
y
e Bearing

lace pulley
assembly.
6.
e
Replace bearing with a
.


 Open-end wren
(14&17 mm)

P
Remove the C-clip (c)
with the C-Clip Plier
and then remove the
pulley Assembly b
using th
Puller.
If the Ball Bearing
failed, rep
Remove the C-clip (D)
with the C-Clip Pliers
and then remove th
idler Assembly by
using the Bearing
Puller then strike
bearing out from the
housing of
7