17
PART 4 - MAINTENANCE
CLEANING
¡·Remove dust with a vacuum or slightly damp cloth.
¡·Never use solvents on the deck or belt. Use of solvents can reduce critical
lubrication of deck and belt.
CENTERING THE BELT
Your Johnson Treadmill is built with a crowned roller to assure proper
tracking of the belt on the center of the deck.
When you run or walk, you may push off harder with one foot than the
other. This uneven deflection can cause the belt to move off center.
Occasionally the belt may need further adjustment to k eep it centered. To
center the belt, use the enclosed Allen wrench to adjust the rear roller
position.
Centering Belt P rocedure:
1)Do not wear loose clothing, or loose jewelr y while making this
adjustment.
2)Never turn the bolts more than 1/4 turn at a time.
3)Always tighten one side and loosen the other to prevent over tightening
or loosing the belt.
4)Select manual program and press start. Adjust belt speed using console
keys to 4 mph (6.4 kph)
After making the adjustment walk on it for 5 minutes to test. If necessar y,
repeat the procedure but never turn the bolts more than 1/4 turn at a time.
Over tightening the belt can significantly shorten the belt life.
To Next Page
Loading...
