23 24
!
The shoulder harnesses must be placed in back of the
two iron tubes.
!
During adjustment, make sure the shoulder harnesses
are not twisted.
!
Use extreme care in threading the shoulder harnesses
according to the figure. If the shoulder harnesses are not
secure, they will not protect your baby properly.
Securing Child in the Infant Car Seat
1. While pressing the harness adjustment button, pull
completely the two shoulder harnesses of the infant car seat.
(Fig. 14)
2. Unlock the buckle of the harnesses by pressing the red
button. (Fig.15)
3. There are 2 positions crotch harness adjusted according to
different requirements.
Position 1 Smaller babies use this position (Fig.16.1)
Position 2 Larger babies use this position (Fig.16.2)
i. Pull the crotch harness out and place it to be level.
(Fig.17.1&Fig.17.2&Fig.17.3)
ii. Rotate the crotch harness anchor to make the short side
forwards, then thread it through the crotch harness slot.
(Fig.17.4)
iii. Rethread it through the slot that is closest to child's
crotch from the front of the crotch harness. (Fig. 16)
4. Place child into the infant car seat and lock the buckle.
(Fig. 18 & 19)
5. Tighten the shoulder harnesses by pulling adjustment
webbing. (Fig. 20)
!
Make sure the space between the child and the shoulder
harnesses is about the thickness of one hand.
Infant Car Seat Installation
The installation instructions vary depending on whether or not
you are using the base. Please refer to the proper section.
!
Do not place the infant car seat on front vehicle seat with
airbag. Death or serious injury can occur. (Fig. 21)
!
When using the infant car seat in a vehicle seat, please
adjust the handle to position 1. (Fig. 5.1)
!
Face your car seat or base toward the rear of the vehicle.
!
Ensure the vehicle safety belt is not loose or twisted.
i. Installing without Base
After fitting the harness to your child and determining which
rear vehicle seat location is best, you are ready to install your
infant car seat.
1. Insert is for infant's protection. Infant weighing under
10kg must use the insert.
2. Before using the insert, please assemble foam. (Fig. 13)
3. After child is placed into the seat, check whether the
shoulder harnesses are at proper height.
Note
To Next Page
Loading...
Need help?
General
