25 26
1.Place the infant car seat onto the vehicle seat where you
wish to put it. Pull the vehicle safety belt out and lock it into
the vehicle buckle, sliding the vehicle lap belt into the side
guides of the infant car seat. (Fig. 22)
2. Slide diagonal belt into the rear guide. (Fig. 23)
3. Pull the belt to fasten the infant car seat tightly and securely.
(Fig. 24)
!
Tension the vehicle safety belt as much as possible,
check that it is not loose or twisted.
!
The vehicle safety belt shall not cause pressure on any
part of the child.
Correctly assembled vehicle safety belt is shown as Fig. 25.
!
Lap belt must pass through the two side guides,
as Fig. 25.1.
!
The vehicle buckle is locked correctly, as Fig. 25.2
!
Diagonal belt must pass through the rear guide,
as Fig. 25.3.
ii. Installing with Base
1. Unfold the load leg from storage compartment. (Fig. 26)
2. After placing the base on the vehicle seat, squeeze load leg
adjustment button to extend the load leg to floor (Fig. 27.1),
the load leg indicator shows green means it is installed
correctly, red means it is installed incorrectly. (Fig. 27.2)
!
The load leg has 8 positions. When the load leg indicator
shows red this means the load leg is in the wrong position.
!
Make sure the load leg is secure by pressing down on the
front of the base.
3. Open the lock-off and route the vehicle safety belt through
the belt path (Fig. 28.1), and lock it into the buckle (Fig. 28.2),
close the lock-off. (Fig. 28.3)
4. Tighten the vehicle safety belt as much as possible while
pushing down on the base, and check it is not loose or
twisted.
!
Check that the safety belt does not move by pulling and
pushing hard on base. If belt loosens or lengthens,
repeat procedure.
The installed base is shown as Fig. 29.
!
Please ensure that there is no gap between the seat and
the bottom of the base.
!
The safety belt must go under the lock-off (Fig. 29.1),
not over the lock-off. (Fig. 29.2)
5. Push the car seat down into the base (Fig. 30), if the car seat
is secure, the car seat indicator shows green. If the car seat
is not secure, the indicator shows red. (Fig. 31)
!
Pull up on the car seat to be sure it is securely latched
into the base.
6. To release the car seat, pull the car seat up while squeezing
the car seat release button. (Fig. 32)
Use with Strollers
Your infant car seat is designed to attach to certain Joie stroller
models featuring a special tray, armbar or calf support.
!
Please make sure your stroller can fit the infant car seat
before purchasing it.
!
Never allow more than one baby in the travel system
at one time.
To Next Page
Loading...
Need help?
General
