27 28
!
Please brake your stroller before assembling the
infant car seat.
!
Check that the parts used to fix the infant car seat are
securely fastened on the stroller.
!
Recline the stroller seat back to the lowest position.
i. Use with Joie Strollers
To assemble the infant car seat on Joie strollers, please
follow these steps:
1. Place car seat into stroller so notches in rockers fit over
edge of armbar, tray or calf support. The car seat will then
automatically click into place. (Fig. 33 & 34 & 35 & 36)
!
If armbar has fabric cover, please detach the Velcro on
armbar cover first. (Fig. 35.1)
!
For the stroller with a special calf support, please adjust
the calf support to the vertical position, detach the
Velcro, and then lift the fabric cover. (Fig. 36.1)
2. Use the straps on both sides of stroller to fix the car seat.
( Fig. 37 & 38 & 39)
!
Try pulling the car seat upwards to check that it is
fitted correctly.
To remove the car seat, release the straps from the car seat,
pull up the stroller release handle to release the car seat from
tray, armbar or calf support, and then lift car seat out of stroller.
Please refer to Fig. 40 & 41 & 42.
Detaching Hood and
Seat Pad
To detach the hood, while pressing the button in the
hood mount, pull the hood bow out. (Fig. 43)
To detach the seat pad, you should refer to the following
steps:
1. You must remove the insert first. To do this simply unlock
the buckle, then unclip the snaps on both sides of the
insert and pull out away from the seat.
2. Remove the crotch pad by detaching the Velcro.
3. You must remove the shoulder harnesses and shoulder
pads. To do this please refer to the section 'Shoulder
Harness Strap Height Adjustment'.
4. Pull out the fastening pieces underneath the edge of the
seat. (Fig. 44)
5. Detach the metal hook from the edge of the car seat, and
then lift it up to seperate the seat pad from the stroller fix
release button A. (Fig. 45)
6. Detach the seat pad from around the adjustment button as
shown in (Fig. 46)
To refit the seat pad simply reverse the steps above, however
make sure that the shoulder harnesses are not crossed over
and not twisted.
To Next Page
Loading...
Need help?
General
