SAFETY EQUIPMENT
12 – English
E
Fig. 1
Fig. 2
Fig. 3
Fig. 4
C
D
1. First remove the following components:
• Chain and guide bar.
• Centrifugal clutch.
Chain brake
Dismantling
!
WARNING!
Check that the chain brake is in the on
position. If it is not, the pressure spring
can fly up causing personal injury.
2. Push the hand guard forward so that the chain brake
is on. See g. 1
3. Unscrew hand guard, two bolts. Note sleeving on the
starter side. See g. 2.
4. Remove bolt (A) and chain guide-plate. See g. 1.
5. Undo the four bolts (B) and remove the chain brake
assembly cover. See g. 1.
6. Press down the retaining bush (C) and remove the
lever arm (D). See g 3.
7. Remove the pressure spring by freeing the rearward
end with a screwdriver. See g 4.
8. Remove the toggle joint (E) with attached brake-
strap. See g 4.
9. Disconnect the brake-strap from the toggle joint.
10. Take out the retaining bush (C) and spring. See g 3.
Inspection
Clean and inspect all components.
The brake-strap thickness must not be less than 0.8 mm
at any point. See g. 5.
To Next Page
Loading...
