ANTI-VIBRATION SYSTEM
38 – English
Fig. 1
Fig. 2
B
1. Use pliers to attach the springs to the tank unit.
2. Attach the springs to the cylinder with the help of a 4
mm Allen key. See g. 1. Tighten the bolts to 10 Nm.
3. Ret the following components:
• Tank unit.
• Cylinder cover.
• Chain and guide bar.
Anti-vibration system
!
WARNING!
The fuel that is used in the chainsaw
poses the following hazards:
1. The fluid and its fumes are poisonous.
2. Can cause skin irritation.
3. Is highly inflammable.
1. Remove the following components:
• Chain and guide bar.
• Cylinder cover.
• Tank unit.
2. Detach the springs from the cylinder with the help of
a 4 mm Allen key. See g. 1.
3. Detach the springs from the tank unit with service
tools 502 52 18-01 and 502 52 18-02. See g. 2.
Dismantling
Clean and inspect all parts.
Cleaning and inspection
Reassembly
To Next Page
Loading...
