CENTRIFUGAL CLUTCH
22 – English
Fig. 1
Fig. 2
Fig. 3
Fig. 4
B
E
D
C
Centrifugal clutch
Dismantling
During dismantling of the centrifugal clutch, the chain
brake must be in the off position.
1. Remove the cylinder cover, chain and guide bar.
2. Remove the chain guide-plate by removing the bolt
(A). See g. 1.
3. Remove the circlip (B) and washer and remove
the clutch drum (C), together with the needle roller
bearing (D) and chain drive-wheel (E). See g. 2.
4. Remove the spark plug, insert the piston stop tool
and unscrew the clutch hub with the clutch tool. Note
- left hand thread. Turn in the direction of the arrow
as shown in g. 3.
The following points (5-7) describe the dismantling of the
clutch hub.
5. Using a screwdriver, lever in the lip of the spring
such that the spring sticks out a little on the other
side. See g. 4.
6. Stretch out the springs with circlip pliers and remove
them from the clutch hub.
7. Remove the clutch shoes.
NOTE!
The clutch springs should not be opened out
more than necessary. Risk of deformation.
To Next Page
Loading...
