Jonsered CS 2172 WH - Page 21

ELECTRICAL SYSTEM
English – 21
Fig. 13
Fig. 14
Fig. 15
Fig. 16
Replacing the generator
1. Before the generator can be replaced, the following
components must be removed:
A. Recoil starter.
B. Flywheel.
C. Silencer.
D. Carburettor.
E. Cylinder.
2. Detach the carburettor space bottom plate by
removing the four bolts. See g. 13.
3. Detach the generator by removing the three xing
bolts. See g. 14.
4. Disconnect the lead from the on/off switch and lift out
the generator.
5. Locate the new generator as shown in g. 14 and
tighten the bolts to 4 Nm.
6. Position the lead as shown in g. 15 and reconnect it
to the on/off switch.
7. Fit the carburettor space bottom plate with the four
bolts. See g. 13. Ensure that the lead is seated in
the recess in the plate as shown in g. 15.
Tighten the bolts to 5 Nm.
8. Ret the components from point 1.
Replacing the heating element in the rear hand grip
(tank unit).
1. Disconnect the two cable clips beside the springs.
2. Remove the ve bolts which secure the front hand grip.
3. Fit the new hand grip and replace the ve xing bolts,
tightening them to 4 Nm.
4. Reconnect the two leads.
Replacing the front hand grip
1. Before the rear hand grip element can be replaced
the following components must be removed:
A. Tank unit.
B. Throttle lock and throttle lever.
2. Disconnect the leads, remove the bolts as shown in
g. 16 and remove the heating element.
3. Insert the new heating element, replace the bolts as
shown in g. 16 and reconnect the cables.
4. Ret the components from point 1.
Replacing the on/off switch
1. Remove the on/off switch and disconnect the leads.
See g. 8.
2. Connect the leads to a new switch and press it into
place.