Jonsered CS 2172 WH - Electrical System

ELECTRICAL SYSTEM
18 – English
Fig. 1
Fig. 2
Fig. 3
Fig. 4
C
A B E D
F
Ignition system
1. Remove the cylinder cover and starter assembly.
2. Release the blue lead (A) (which connects to the
stop switch) from the ignition module (B). See g. 1.
3. Remove the HT lead (C) from the spark plug,
release both leads from the cable guide (D) and lift
out the cable guide. See g. 1.
4. Undo the two M4-bolts and remove the ignition
module (B). See g. 1.
5. Undo and remove the two pawls (E) for the recoil
starter. See g. 1.
6. Remove the spark plug and t the piston stop tool in
the spark plug hole. See g. 2.
7. Release the ywheel nut. Undo the nut until it is in
line with the thread on the shaft outer end. See g. 3.
8. Attach the ywheel puller. Tighten down the two M5
x 25- bolts approx. 10 turns. Tighten the central bolt,
while preventing rotation with the holding tool, until
the ywheel comes loose. See g. 4.
9. Remove the puller, nut, washer and ywheel.
Dismantling
Cleaning and inspection
Clean all components, especially the tapers on the
ywheel and shaft.
Check that the ywheel is not cracked or damaged in
any other way.