lish
PRESENTATION
Choke control FR 2216A2
The choke lever is used for cold starting and to give the
engine a richer fuel mixture.
For cold starting the lever is moved backwards to its end
position.
Speed limiter, FR2213MA, FR2216A,
FR2216A2
The speed of the machine is steplessly regulated with two
pedals. Pedal (1) is used to drive forwards, and pedal (2) to
drive backwards.
Cutting unit
FR 2211R
has a cutting unit with rear ejection, i.e. clippings
are thrown behind the cutting unit.
FR 2211 M, FR 2213 MA, FR 2216 A and FR 2216 A2
have
a 3-blade Combi-unit
The Combi-unit, equipped with a Mulching-plug, finely chops
the cuttings to fertiliser. Without the Mulching-plug the unit
works in the same way as a rear ejection unit.
Lifting lever for the cutting unit
The lift lever is used to set the cutting unit in transport or
mowing position.
If the lever is pulled backwards the unit is raised and the
blades automatically stop rotating (transport position).
If the lock button is pressed in and the lever is moved forwards
the unit will be lowered and the blades will automatically start
to rotate (mowing position).
The lever can also be used to temporarily regulate the cutting
height, e.g. for a small mound in the lawn.
Cutting height adjustment lever
The cutting height can be adjusted to 7 different positions with
the cutting height lever.
Combi-unit 40-90 mm (1 9/16” - 3 9/16”)
Seat
The seat has a jointed attachment on the front edge and can
be tipped forward.
The seat can also be adjusted lengthways.
FR 2211R, FR 2211M, FR 2213MA,
FR 2216A
Loosen the handles under the seat and adjust it forwards or
backwards to the desired position.
!
WARNING! Make sure that branches do not
obstruct the pedals when mowing under
bushes. Otherwise there is a risk you may
lose control.
To Next Page
Loading...
