R
MODEL J-239
JOPEVI
PAGE
6
The machine will carry packaging which is sufficient to avoid knocking or scraping any of its components. We
advise that wooden packaging, in box or cage form, should always be used, always with adequate protection and
the machine properly secured. The machines should always travel in the vertical position and never be
overturned.
REMEMBER
THE MACHINE MUST NOT BE OVERTURNED.
2.3. UNLOADING AND LEVELLING.
The machine should be unloaded with a forklift and placed on a the floor. After the machine is un-crated and
unpacked, it can be transported by pallet jack to its permanent location. The machine comes out of the factory
totally leveled, and does not need to be secured to the floor. It incorporates rubber leg tips so it will not move
with vibration during use. The floor underneath the machine should be strong and level.
2.4. LOCAL C CONDITIONS.
In order to create optimum working conditions, the machine should be situated beneath a light source of 300
lux minimum.
2.5. LEARNING INSTRUCTI ONS.
BEFORE STARTING THE MACHINE, READ THESE WARNINGS CAREFULLY !
This machine must be plugged into a 110V power outlet
-Before connecting the machine to the electrical outlet or the compressor, it should be placed in its permanent
location. Do not connect any electrical devices to the machine before it has been placed in its permanent
position.
-Cleaning,manipulation or replacement of any parts of the machine must always be carried out with the
machine disconnected from the main power supply.
-Do not remove from the machine any parts which protect the user from possible accidents, or adhesive labels
or signs indicating electrical or hazardous components.
-The machine must always be connected to a 110V outlet (power supply).
To Next Page
Loading...