JPS RTU-292 - Tel-Line Phone Command; Tel-Line Radio Command

RTU-292 Operations Manual
5.3.13 Tel-Line Phone Command
TEL_LINE_PH <ON|OFF|?> <CR>
This command is to enable, disable or query the current status of Tel-Line Phone. Note that enabling
Tel-Line Phone will put the PSTN in an Off-Hook status. Disabling Tel-Line Phone will only put the
PSTN back on hook if Tel-Line Radio is also disabled. To quickly disconnect the PSTN use the DISC
command.
Expected Response: Tel-Line Phone Response.
Examples:
TEL_LINE_PH ON <CR> ; Command to enable the Tel-Line Phone path.
%TEL_LINE_PH ON E0 <CR> ; Status returned showing that Tel-Line Phone is enabled.
TEL_LINE_PH ? <CR> ; Command requesting the status Tel-Line Phone.
%TEL_LINE_PH OFF E0 <CR> ; Status returned showing that Tel-Line Phone is disabled.
5.3.14 Tel-Line Radio Command
TEL_LINE_RAD <ON|OFF|?> <CR>
This command is to enable, disable or query the current status of Tel-Line Radio. Note that enabling
Tel-Line Radio will put the PSTN in an Off-Hook status and cause the DSP telephone hybrid to adapt.
Disabling Tel-Line Radio will only put the PSTN back on hook if Tel-Line Phone is also disabled. To
quickly disconnect the PSTN use the DISC command.
Expected Response: Tel-Line Radio Response.
Examples:
TEL_LINE_RAD ON <CR> ; Command to enable the Tel-Line Radio path.
%TEL_LINE_RAD ON E0 <CR> ; Status returned showing that Tel-Line Radio is enabled.
TEL_LINE_RAD ? <CR> ; Command requesting the status Tel-Line Radio.
%TEL_LINE_RAD OFF E0 <CR> ; Status returned showing that Tel-Line Radio is disabled.
JPS Communications, Inc.
5-9