JPS RTU-292 - Speed Dial Response; Tel-Line Phone Response; Tel-Line Radio Response

RTU-292 Operations Manual
5.4.12 Speed Dial Response
%SD <nn> <num|”is empty.”> Exx <CR>
Type: Synchronous.
Response To: Speed Dial Command.
This response shows the contents of a given speed dial memory location.
Examples:
%SD 5 5551212 E0 <CR> ; Status indicating that speed dial location 5 contains the number 555-
1212.
%SD 21 is empty. E0 <CR> ; Status indicating that speed dial location 21 is empty.
5.4.13 Tel-Line Phone Response
%TEL_LINE_PH <ON|OFF> Exx <CR>
Type: Synchronous.
Response To: Tel-Line Phone Command.
This response indicates the Tel-Line Phone path status.
Examples:
%TEL_LINE_PH ON E0 <CR> ; Status indicating that the Tel-Line Phone path is enabled.
%TEL_LINE_PH OFF E0 <CR> ; Status returned indicating that the Tel-Line Phone path is disabled.
5.4.14 Tel-Line Radio Response
%TEL_LINE_RAD <ON|OFF> Exx <CR>
Type: Synchronous.
Response To: Tel-Line Radio Command.
This response indicates the Tel-Line Radio path status.
Examples:
%TEL_LINE_RAD ON E0 <CR> ; Status indicating that the Tel-Line Radio path is enabled.
%TEL_LINE_RAD OFF E0 <CR> ; Status returned indicating that the Tel-Line Radio path is disabled.
JPS Communications, Inc.
5-16