EasyManuals Logo

JRC FF50 Service Manual

JRC FF50
26 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #12 background imageLoading...
Page #12 background image
10
4. Installing the display unit
Connecting The Power Supply and Transducer cables
(1) Connecting the Power Cables
1, Use CFQ-6382 for the power cable.
2, Connect the Power cables as indicated below.
Cable Connector pin NO. Polarity
Black 1 -
Red 2 +
3. At powering on,2.5A current is conduced to the FF50 for one second.
Current capacity of circuit breaker, if any , must be suitable for the current.
(2) Power Cable Connecting Procedure For AC specification
1. Connect DC power supply ,then connect the power cable to DC power supply.
2. Dont use the DC power supply of switching form power supply.
If you use the switching power supply , RX signal is interfered by power supply.
(3) Power Cable and transducer Wiring Procedure
1. Dont try to bundle the radio equipment coaxial cable and the audio speaker
cable with the Fish finder power cable.
Such practice can generate noise on the radio and audio equipment.

Other manuals for JRC FF50

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the JRC FF50 and is the answer not in the manual?

JRC FF50 Specifications

General IconGeneral
BrandJRC
ModelFF50
CategoryFish Finder
LanguageEnglish

Related product manuals