18
8. Master Reset and Language Select
A MASTER Reset can be performed by either the SOFT
Reset or HARD Reset.
The SOFT Reset restores all set values except the
WAYPOINT data and ROUTE PLAN data to the original
factory set-up values.
The HARD Reset restores all set values to the original
PLAN data.
When you want to keep the WAYPOINT and ROUTE PLAN
data, execute the SOFT reset. When the MASTER reset is
executed, the CUSTOM DEFAULT is initialized to the
factory-set default settings.
When you push to BRT/PWR turn the power on while
pushing CUSTOM and MENU at the same time, the
LANGUAGE SELECT display appears.
Press the JOYSTICK up or down to select a language
and push it in to open the MASTER RESET type select
display.
Press the JOYSTICK up or down to select HARD or SOFT
and push it in to select OK or CANCEL for the selected
language and the reset type.
Press the JOYSTICK to the left or right to select OK and
push it in to execute the MASTER reset.
Select CANCEL and push the in to return to the language
select display.
After the MASTER reset is executed, the FF50 is rebooted
automatically.
To abort the MASTER reset, turn the power off and then
turn the power on again.
Note:
When a backup error occurs, the FF50 enters the MASTER
Reset
mode automatically, and the language select menu opens.
In this case , you cannot abort the MASTER reset. Be sure
not to turn the power off during the MASTER reset.
To Next Page
Loading...
Need help?
General
