JRC JCY-1850 - 1.3.2 Stopping the System

1. Operation
6
1.3.2 Stopping the System
y To stop the equipment, follow the procedures described below.
ATTENTION
To operate the Recording Control Unit, the front door has to be unlocked and
opened.
ATTENTION
Do not turn off the breaker of the power distribution board while the
system is active. Otherwise, the system is battery-operated by the Power
Supply Unit.
ATTENTION
Before turning off the Recording Control Unit, be sure to stop recording data
to the CF CARD by pressing the CARD STOP SWITCH on the Main Control
Board. Otherwise, data may not be recorded to the CF CARD.
1. Stopping the Recording Control Unit
1) Unlock the front door with the key and open it.
2) Be sure to stop recording data to the CF CARD by pressing the CARD STOP SWITCH on
the Main Control Board.
y Make sure that the CARD LED on the Main Control Board is off.
y Be aware that if the Power Supply is turned off while the CARD LED is on, data may
not be recorded to the CF CARD.
3) Turn off the Power SWITCH of the POWER Supply Unit.
4) Then all the LEDs are turned off.
2. Stopping the Operation Panel Unit
If the Power Supply Unit in the Recording Control Unit is turned off, the Operation Panel
Unit is also turned off.
3. Stopping the Protective Capsule Unit
If the Power Supply Unit in the Recording Control Unit is turned off, the Protective
Capsule Unit is also turned off.
4. Stopping the Microphone Unit
If the Power Supply Unit in the Recording Control Unit is turned off, the Microphone Unit
is also turned off.
5. Stopping the Option Units
If the Power Supply Unit in the Recording Control Unit is turned off, the Option Units are
also turned off.