Chapter 3 Operation Method 3-8
① Accumulated sailing
distance (total sailing
distance or section
sailing distance)
Whenever the [TRIP/TOTAL] button is pressed, the display is
switched between the total sailing distance and the section
sailing distance.
As shown below, when a vessel leaves point A, stopover at
points B, C, and D, then goes back to point A, the [TRIP] (section
sailing distance) is used to calculate the distance of each of the
individual segments between the point. The [TOTAL] (total
sailing distance) is used to calculate the total run distance of the
whole journey.
② [TRIP/TOTAL] button Whenever the button is touched, the display is switched between
the total sailing distance and the section sailing distance.
③ [TRIP RESET] button This button can be used to reset the section sailing distance to 0.
Remote display NWZ-650SDR/840SDR trip display would
“--------“ at first time. Do trip reset.
Notice: Resetting of the total sailing distance is unable to general users.
For resetting the total sailing distance, please request to the store, nearest JRC agent, JRC
marine service department, sales department, regional office, branch or sales office.
C
To Next Page
Loading...