5-1 Chapter 5 Installation Method
5
Chpater 5 Installation Method
Electrical work for this equipment must be requested to the store, nearest
JRC agent, JRC marine service department, sales department, regional
office, branch or sales office.
Conducting electrical work by anyone other than the specialized
maintenance staff may result in an accident or an equipment fault.
Use the screws that are specified in the installation manual when installing
this equipment.
Use of any other screws may result in an injury or an equipment failure
caused by the equipment dropping down.
Use the specified power supply cables, signal cables, and earth cables.
Failure to comply may cause faults in some other equipment or cause this
equipment to become susceptible to faults from some other equipment.
When mounting the equipment on the wall, mount it firmly to avoid the
equipment from dropping under its own weight.
Failure to comply may result in an injury caused by the dropping equipment.
When installing this equipment, make sure that the equipment is connected
to the earth terminal and the earth plate properly.
Failure to comply may results in an electric shock at an equipment fault or
an electric leakage.
Do not place this equipment inside of a cupboard or cover it with a
cardboard.
Failure to comply may cause heat accumulation, resulting in fire or an
equipment fault.
Do not use or leave the equipment under direct sunlight for a long time or in
the temperatures above 55°C. (except wing display)
Otherwise, fire or a malfunction may occur.
Do not install the equipment in a place under the influence of water,
humidity, vapor, dust or soot. (except wing display)
Failure to comply may result in fire, an electric shock, or an equipment
malfunction.
Do not place this equipment in a location under the influence of frequent
vibrations or impact.
Failure to comply may cause the equipment to drop or fall over, resulting an
injury or an equipment fault.
To Next Page
Loading...