4-17 Chapter 4 Menu Settings and Configurations
4
4.3.8.2 Initial Settings
Information on the latitude/longitude, date and time can be set in this menu according to the actual
information.
1. Touch the [INIT] button in the submenu.
The 1
st
page of the information setting screen is displayed.
2. Touch the [-]/[+] button, the [LATITUDE] can be switched between the north latitude
and the south latitude; the [LONGITUDE] can be switched between the east longitude
and the west longitude; the [ALTITUDE] (height of the GPS compass sensor from the
surface of sea) can be decreased or increased every 10m.
3. Touch the [LATITUDE], [LONGITUDE] and [ALTITUDE] button, the numeric entry screen
is displayed.
Touch the
botton to delete the existing numbers.
Touch the panel to enter the numbers.
Touch
botton to confirm the entry, and close the numeric entry screen.
The setting ranges are as follows.
[LATITUDE]: N/S 00 ﾟ 00' to 90 ﾟ 00' (initial value: N00 ﾟ 00')
[LONGITUDE]: E/W 000 ﾟ 00' to 180 ﾟ 00' (initial value: E000 ﾟ 00')
[ALTITUDE]: 0.00 to 99.9m (initial value: 0.00)
To Next Page
Loading...