JRC JLN-720 - Display Mode Selection (for Remote Display)

4-25 Chapter 4 Menu Settings and Configurations
4
4. Set [HOUR], [MINUTE] and [TIME ZONE] to the actual values by touching the [-]/[+]
buttons.
The setting ranges are as follows.
[HOUR]: 0 to 23 (initial value: 0)
[MINUTE]: 0 to 59 (initial value: 0)
[TIME ZONE]: -12:00 to +12:00 (initial value: 00:00)
5. Confirm the setting and close the [D AT E T IM E] menu by touching the
button.
4.3.13 Display Mode Selection (for remote display)
Display mode of the remote display can be selected in this menu.
1. Touch the [DISP MODE] button in the main menu of remote display.
Display mode setting screen is then displayed.
2. Set the display mode by touching the [-]/[+] buttons.
DIGITAL: Display in digital mode (initial value)
ANALOG: Display in analog mode
Display in digital mode Display in analog mode
3. Confirm the setting and close the [DISP MODE] menu by touching the
button.