3.9 APPLIED OPERATIONS
3ņ106
3
y
y y
Load and save of the Rdar trails.
Procedure 1 Press [RADAR MENU] key twice.
Press [7] key.
Alternatively, hold down the [TRAILS]
key until the menu appears.
Press [9] key.
The RADAR Tails Setting Menu will appear.
[1] Loading Trails File
x Presse [1] key.
The saved trail files are displayed.
x Select the file to be loaded
Confirmation warining is displayed.
Select “Yes” for loading.
It takes a few second to be loded.
Note: When the saved trail position is too far from own ship position, the saved trails can not be
loaded.
On the standby mode, however, far trail positions can be loaded. In that case, the own ship
position is changed to the loaded trail position temporally.
After loading, Range scale, Trails mode (True / Relative) and Max interval are set to loded
settings.
[2] Saving Trails File
x Presse [2] key.
The File Save menu is displayed.
x Using the cusor, enter the file name and click “ENT”
Confirmation warining is displayed.
Select “Yes” for saving.
It takes a few second to be loded.
Note: When the own ship position data are not available,
trails can not be saved.
To Next Page
Loading...
