ņ51
7.5.1 Scanner Safety Switch Setting (Safety Switch)
Use this switch to measure the transmission/reception performance while the antenna is in stopped state.
Procedure 1 Hold down [RADAR MENU] key.
The Code Input Menu will appear.
2 Press [0] key.
3 Move the cursor onto the “ENT” button
in the Code Input menu, and press
[ENT] key.
The Adjust Menu will appear.
4 Press [2] key.
The Maintenance Menu will appear.
5 Press [1] key.
Setting items for the scanner safety switch will
appear.
6 Select the item you want to set, pressing the numeric key [1] to [4].
1. TX OFF:
Stops transmission. (The screen remains in the transmission status.)
2. STANDBY: (Normal setting)
Stops transmission. (The screen switches to the standby status)
3. TX-ON:
Continues transmission without changes. (The display unit remains in transmission
state.)
(However, errors in bearing signals etc. are to occur due to safety switch-off.)
4. IGNORE ERROR:
Continues transmission without changes.(Errors in bearing signals etc. due to safety
switch-off are also ignored.)
7 Change the setting back to 2. Standby when the work is finished.
Exit 1 Press [RADAR MENU] key.
The Main Menu will reappear.
To Next Page
Loading...
