8─63
ATA
1. Vector Const
5
2. Video TD Level
15
8
0. EXIT
3. Video High Level
1
4. Video Low Level
NARROW
5. Gate Size
OFF
6. Limit Ring
Vector Constant
Procedures 1 Press [9] key while the Adjust Menu is
open.
The SP/ATA INIT Setup Menu will appear.
2 Press [2] key.
The ATA Menu will appear.
3 Press [1] key.
The window for setting vector constants will
appear.
4 Select the value you want to set,
pressing the numeric keys [1] to [8].
Exit 1 Press [RADAR MENU] key.
The Main Menu will reappear.
z Do not change the set value carelessly.
The vector constant shall be set to 5 normally. If the
vector constant value is higher, a target’s vector will
be better followed up when the target and own ship
change their course or speed, but the vector
accuracy will be lower on the contrary.
Attention
To Next Page
Loading...
