JRC JMR-5410-4X - Page 377

13-5 Section 13 Setting up the Operation Mode
１
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
APP A
APP B
Page 3
Setting Item Description of Setting Setting Value
Video Latitude Set up the radar image. Narrow / Normal /
Wide / Super Wide
Video Noise Rejection
Set up to remove noise and signals which are
considered to be clutters of radar images.
Off / Level1 (Low) /
Level2 (High)
AUTO Dynamic Range
Control
When this is selected, the dynamic range is
automatically adjusted.
To enable: Select
To disable: Clear
Process Switch
Specify an area and set up a mode for
performing video processing on the inside and
outside of the area.
Off / Range Fix / AUTO
2nd Process Mode Set up a processing mode used in the outside
of the area. The setting is enabled when an
option other than [Off] is selected in the
[Process Switch] combo box.
PROC Off
3Scan CORREL
4Scan CORREL
5Scan CORREL
Remain
Peak Hold
Bird
Process Switch Range Set up the boundary range of a particular area.
The setting is enabled when [Range Fix] is
selected in the [Process Switch] combo box.
0.1 to 25.5 NM
Fast Target Detection
When this item is enabled, high-speed moving
targets that are suppressed by the scan
correlation processing can be displayed more
easily.
The setting is enabled when [2nd Process
Mode] is within the range of [3Scan CORREL]
to [5Scan CORREL].
To enable: Select.
To disable: Clear.