Section 13 Setting up the Operation Mode 13-6
Page 4
Setting Item Description of Setting Setting Value
Trails Mode Select a radar trail display mode. True / Relative
Trails Ref Level Set an image level required to draw radar trails.
The higher the level is, the higher the threshold
value for drawing radar trails becomes.
Level1 (Low)
Level2
Level3
Level4 (High)
Trails Reduction
Set a radar trail thinning processing level. The
higher the level is, the stronger the effect of the
thinning processing level becomes.
Off
Level1 (Wide)
Level2
Level3 (Narrow)
Use MAX Length Preset
(Check box)
By selecting/clearing the check box, the
using/not using of the setting at the change of
the observation scene is determined. When the
check box is selected, select the maximum
value of the time for displaying the radar trails
from the combo box.
Short / Long
Maximum length
selection
(Combo box)
Trails Length Set up the interval for displaying radar trails. <Setting [Short]>
Off / 15 s / 30 s / 1 min
/
3 min / 6 min / 10 min /
15 min / 30 min / 60
min
<setting [Long]>
Off / 30 min / 1 hour /
2 hour /
(subsequently, 1-hour
units)
24 hour
Use Vector Length
Preset
(Check box)
By selecting/clearing the check box, the
using/not using of the setting at the change of
the observation scene is determined. When
this check box is selected, set a vector length
to be assigned to the observation scene.
1 to 120 min
Vector length input
(Text box)
To Next Page
Loading...
