JRC JMR-5410-4X - Page 414

Section 13 Setting up the Operation Mode 13-42
Item saved
Preferences save target Value set at shipment from
factory, value displayed
when the [Default display
configurations] is pressed
Location Item
Parallel index
lines
RADAR screen
- PI (Parallel Index)
RADAR screen – PI
(Parallel Index)
• Display On/Off
• Control right
PI measurement
reference point (blank
space/C/D and floating
position. In the case of
C, the information is
stored in the form of
DC coordinate and in
the case of D, the
information is stored in
the form of
latitude/longitude.)
• Display On/Off: Off
• Control right: On
• Bearing value: 0°
• Interval: +0.00 NM
Display for All Lines: Off
Mode: All
Operation Area: One Side
Floating: Off
Heading Link: Off
Reference Bearing: True
Display
mode of the
radar picture
RADAR screen
-
Range and mode
information
• Motion mode
• Bearing mode
True motion
North-up
TM reset position
Stabilisation
Sea/Ground
RADAR screen
-
Range and mode
information
• Stabilisation mode
(combo box)
GND
Off-centring RADAR screen
- Range and mode
information
• Off Centre button →
Off Centre On/Off state
and Off Centre DC
position
Off Centre: Off = On Centre
Target trails
RADAR screen
- Other ship's information
• Trail true/relative
• Trail length
• Trail true/relative: True
• Trail length: 6 min
Past
positions
RADAR screen
- Other ship's information
• Past POSN Off
Vector mode
RADAR screen
- Other ship's information
•
Vector/past position
true/relative
Relative
Vector time
RADAR screen
- Other ship's information
Vector Length 6 min