INMARSAT mini-C JUE-95SA OPERATION GUIDE
Step 3 Security alert is kept transmitted regularly at set intervals and the address set beforehand.
Step 4 To cancel the security alert transmission, make the button to OFF status by pushing the button again.
Security Alert test transmission procedure
Step1 Push the Test Button of IME, then the button is illuminate.
Step 2 Push down Security button.
Lamp lights for 30 seconds, then blinks, and starts Test transmission.
Step 3 Blinking of Test button stops and lights, when the test transmission is completed.
Press Security button again.
Step 4 Push Test button.
Light of Test button is disappeared.
・ Turn off all buttons when pushed two or more buttons at the time of transmission.
Security Alert transmission is not be canceled any button is remained on.
・ Confirm all of security buttons are turned off before the test transmission.
Test transmission is impossible any button is remained on.
Note
Certain making all of the security buttons to OFF status.
Light of Test button will not disappear, and buzzer begins to sound even Test button is pushed, when the
Security button is not turned off correctly, on the status of Step 3.
Buzzer sounds and test button lights with pushing the test button under any security button is not OFF
status.
Security Alert transmission is not canceled with any button is remained turned on.
Note
＜Duration time for security alert test transmission＞
Ｎumber of Transmission message setting
1（5 minutes）2（17 minutes）3（29 minutes）4（41minutes）5（53 minutes）approximately
The transmitting duration depends on the message length or condition of satellite connection and etc.
Reference
To Next Page
Loading...
Need help?
General
