Operator’s Manual Tine Rake Dethatcher
20195 South Diamond Lake Road, STE 100
Rogers, MN 55374
800.966.8442
www.jrcoinc.com
10
3. Secure with 5/8 hitch pin and hairpin
cotter.
4. Insert 3/8 x 5” clevis pin in hole in
between side plates. Secure with
circle cotter. This pin will be used
later, when folding the dethatcher for
transport.
5 Adjustments
1. Adjust the height of the dethatcher with
the rake on level, paved ground.
2. Level the dethatcher by adjusting the
shaft collars on each caster assembly. Use
a 5/32” allen wrench to loosen set screws
in shaft collars and adjust each wheel. The
caster may need to be rotated to locate
the set-screw. The top of the rake deck
should be 9 ½” from the ground.
3. When adjusted properly, the tips of the
tines should be approximately ¾” from a
hard surfaced ground. When the
dethatcher is on turf, the tines will engage
the grass and work back and forth lifting
and flicking dead grass and thatch.
To Next Page
Loading...