Need help?Do you have a question about the JTS CS-1CU and is the answer not in the manual?
General| Type | Chairman Unit |
|---|---|
| Microphone | Electret condenser |
| Polar Pattern/Directivity | Cardioid |
| Cable Length | 2 m |
| Impedance | 200Ω |
| Maximum Sound Pressure Level | 125 dB |
| Connector | 8 pin mini DIN |
| Frequency Response | 50 Hz - 18 kHz |
Describes the controls and features on the top panel of the CS-1CU controller.
Details the connections and ports located on the rear panel of the CS-1CU controller.
Identifies and describes the operating elements of the CS-1CH (Chairperson) and CS-1DU (Delegate) microphone stations.
Details the process of connecting multiple microphone stations using the "Trunk in/out" jacks.
Instructions for connecting an additional microphone or wireless receiver to the system.
Guide for connecting line-level signal sources, amplifier systems, and telephone couplers.
Details on connecting headphones and the main power supply to the JTS conference system.
Describes how to choose and configure different discussion modes like Over Ride, Chairman Only, and Open Mode.
Explains how to switch microphones on/off, adjust volume, and set sensitivity for CS-1DU units.
Details operation for CS-1CH stations, including the priority button and its settings.
Guides on adjusting total volume, speaker/headphone volume, and external microphone input.
Instructions for setting the system's clock and using the stopwatch feature.
How to perform a system test and activate/deactivate the key lock feature.
Technical specifications for the CS-1CU controller, including station capacity and cable length.
Technical specifications for CS-1CH and CS-1DU microphone stations, including type, pickup pattern, and dimensions.
To Next Page
