– 35 –
Press the " Color change mode select" button on the mem-
ory switch data list screen.
Refer to
"II-2-29. Changing memory switch data" p.85
for the
memory switch data changing procedure.
When automatic changeover mode
is selected,
changeover of the needle is carried out according to the color
change commands input in pattern data.
Refer to
"II-2-8. How to input color change commands in pat-
tern data" p.36
for the procedure for inputting color change
commands in pattern data.
During the automatic changeover mode, automatic changeover
mark
on the sewing screen.
When manual changeover mode
is selected, needle
changeover button (when the right needle is selected:
; when
the left needle is selected:
)
is displayed. The needle
used for sewing is changed over between the right and left needles
every time the button is pressed.
Be aware that the feeding frame comes down when the needle
changeover is executed.
During the manual changeover mode, color change commands in
pattern data are ignored.
2-7. How to change the color change mode
To Next Page
Loading...
