– 71 –
Display the data input screen.
Only in case of the data input screen (pink) it is possible to input
the combination data. In case of the sewing screen (green),
press READY switch
to display the data input screen (pink).
Pattern No. has not been registered in the initial state, and the
rst pattern selection button is displayed in the blank state.
Display the pattern No. selection screen.
When PATTERN SELECTION button
is pressed, the
pattern No. selection screen is displayed.
Select the pattern No.
When UP/DOWN SCROLL button
is pressed, pattern
No. buttons
which have been registered are changed over in order.
It is also possible to display the pattern No. input screen by
means of NUMBER INPUT button
and input a pattern
No. directly. The contents of pattern data are displayed in the
buttons. Here, press the pattern No. buttons you desire to select.
(2) Creating procedure of the combination data
Determine the pattern No.
When ENTER button
is pressed, the pattern No. se-
lection screen is closed and the selection is nished.
Repeat steps
through
as many as the number of pat-
tern Nos. you desire to register.
When the rst register is determined, the second pattern selec-
tion button
is displayed.
Repeat steps
through
as many as the number of pattern
Nos. you desire to register.
When UP or DOWN SCROLL button
is pressed,
the PATTERN NO. button can be selected. The selected PAT-
TERN NO. button is displayed in pink
.
When the PATTERN NO. INSERT button
is pressed, a
step is inserted before the pattern No. being selected (displayed in
pink). When PATTERN NO. button
being displayed is pressed
to select a different pattern No., the pattern No. is changed over.
If the programmed combination data extends over two or
more screens, the next screen can be displayed by means of
SCREEN SCROLL button
.
Check to be sure that the selected-mode changeover
button
is set to the pattern registration mode.
If the mode is not the pattern registration mode, press
the selected-mode changeover button.
To Next Page
Loading...
