PRESSER FOOT AND FED9
DOG
5 kg
(ll’lbr).
-
if a pressure of
mare
than
6
kg(13.2
Ibs)
is
required, use the exchanging rpring in the
atcersory box
The presser foot hand lifter
To stop the prerser foot at the lifted po-
sition:
1.
Rotate
the hand liiter in the
war
of the face
part either to right or left.
2. The presser foot will go up about 5 mm
(13/64”) and rtopi.
3.
ia
lower the presser foot, activate the knee
lifter
once
and the presw foot will cmne
down
to
the original position.
4. With the knee liiter, the prerrer foot
nilI
go up about
Wmm(25/64”)
Height of the feed dog
The height a, the feed dog from the surface
of the throat plate is set from 0.7.0.8mm. In
sewing
light weight materiali, if this height is
too
high, shrink-stitching may
result.
To
adjust the height of the feed dog:
7.
Looseri the clamping
scre~v
of the
teed
driv-
ing fork of the compound feed.
2.
>M~ave
the feed dog base up and dawn and
.tdjust.
3. After adjusting, tightly tighten the clamping
5crew.
cl.?-o.*mm
To Next Page
Loading...
