Attention:
Turn power switch to off ("O")
when carrying out any of the
above operations!
Raise the presser foot.
Press the black lever (e) and
the foot will disengages.
Lower the presser foot holder
(b) until the cut-out (c) is
directly above the pin (d).
Press the black lever (e).
Lower the presser foot holder
(b) and the presser foot (f) will
engage automatically.
Raise the presser foot bar (a).
Remove and Attach the presser
foot holder (b) as illustrated.
Attach the edge/quilting guide
(g) in the slot as illustrated.
Adjust according to need for
hems, pleats, etc.
Removing the presser foot (1)
Attaching the presser foot (2)
Removing and Attaching the
presser foot holder (3)
Attaching the edge/quilting
guide (4)
To Next Page
Loading...
