JUKI JX-100 LED - Default Chapter; Table of Contents

Operation manualⅠ
For the safe operation of machinery
Table of contents
Introduction .....................................................................................................S-1
Overview of This Manual............................................................................................ S-1
Notational Conventions .............................................................................................. S-1
Organization of This Manual....................................................................................... S-1
Description .................................................................................................................. S-2
Chapter 1 Overview of the Machine ............................................................ 1-1
1.1. Overview of this machine................................................................ 1-1
1.2 Configuration of the machine .......................................................... 1-1
Chapter 2 Operation Procedure................................................................... 2-1
2.1 Flow of PWB production.................................................................. 2-1
2.2 Operating method ........................................................................... 2-2
Chapter 3 Various processing during production ..................................... 3-1
3.1 When components run out (If the check box "Stop system when
components run out" is checked on the "Operation
option" screen) ................................................................................ 3-1
3.2 When components run out (If the check box "Stop system when
components run out" is not checked on the "Operation
option" screen) ................................................................................ 3-2
3.3 When a mark recognition error occurs ............................................ 3-3
3.4 Laser dirty error............................................................................... 3-4
3.5 Various errors (LA recognition error, tombstone error or
irregularly-shaped component error) occurs ................................... 3-5
3.6 When a nozzle error occurs ............................................................ 3-6
3.7 Component replenishing function at occurrence of no
components due to a temporary stop.............................................. 3-7
3.8 Continuous PWB production........................................................... 3-8