Need help?Do you have a question about the JUKI FX-3R and is the answer not in the manual?
General| Brand | JUKI |
|---|---|
| Model | FX-3R |
| Category | Industrial Equipment |
| Language | English |
Procedure for replacing the magnescale on the X-Y unit.
Procedure for replacing limit and origin near sensors on the X-Y unit.
Procedure for replacing and adjusting the head unit.
Procedure for replacing motors within the head unit.
Readjustment procedures after head unit component replacement.
Procedure for replacing the bad mark sensor.
Procedure for replacing the OCC assembly.
Procedure for replacing the CCD camera and lens.
Procedure for adjusting focus of the OCC camera.
Readjustment procedures after OCC unit replacement.
Procedure for replacing transport unit motors.
Procedure for replacing IN and OUT sensors.
Procedure for replacing WAIT, STOP, and C-OUT sensors.
Procedure for replacing the support table motor.
Procedures for automatic PWB width adjustment.
Procedure for replacing the system disk.
Procedure for replacing the SSD.
Procedure for setting up the BIOS after SSD replacement.
Network setup for IS communication.
Installing system programs and FlexlineDB.
Procedure for upgrading the FX-3R system version.
Information about the power supply unit.
Description of the structure of the power supply unit.
Information about the control unit.
Description of the structure of the control unit.
Details on the CPU board.
Details on the position board.
Details on the cPCI-8994 board.
Details on the ETHER-MAIN board.
Details on the IP-X5 board assembly.
Details on the ATX power supply.
Information about the X-Y unit.
Description of the structure of the X-Y unit.
Information about the Z-θ unit.
Description of the structure of the Z-θ unit.
Adjusting the stepping driver.
To Next Page
