FX-3R Maintenance Guide
iii
Rev. 1.00
5-12. Replacing the Support Table ENC........................................................................5-17
5-13. Replacing the Backup Stopper (for EN Type Only) ..............................................5-18
5-14. Auto PWB Width Adjustment................................................................................5-21
5-14-1. Replacing the AWC Motor.................................................................................................. 5-21
5-14-2. Replacing the AWC Origin Sensor..................................................................................... 5-22
5-14-3. Replacing the Transport Stopper Interference Sensor....................................................... 5-22
5-15. Replacing the Barcode Reader (On-Demand Production, Option for SCS)..........5-23
[6] CAL BLOCK ............................................................................................6-1
6-1. Replacing the CAL Board Assembly.......................................................................6-1
[7] ATC .........................................................................................................7-1
7-1. Replacing the Air Cylinder ......................................................................................7-1
7-2. Replacing the ATC OPEN and CLOSE Sensors ....................................................7-2
7-3. Adjusting the Speed Controller ...............................................................................7-3
[8] FEEDER BANK, REPLACEMENT TABLE AND ELECTRIC BANK
(OPTIONAL) ...........................................................................................8-1
8-1. Common Parts and Units for Mechanical Feeder and Electric Feeder ...................8-1
8-1-1. Replacing the Bank-Up Cylinder .......................................................................................... 8-1
8-1-2. Adjusting the Speed Controller of the Bank-Up Cylinder (Optional Replacement Table)..... 8-2
8-1-3. Replacing the Bank-Up Detection Sensor (Optional Replacement Table) ........................... 8-2
8-1-4. Replacing the Selector Switch (Optional Replacement Table)............................................. 8-3
8-1-5. Replacing the Roller Lever (Optional Replacement Table) .................................................. 8-3
8-1-6. Replacing the Cables and Connectors of Replacement Table (For Intelli trolley) ................ 8-4
8-1-7. Replacing the Antenna of the Replacement Table (For Intelli trolley) .................................. 8-6
8-2. Bank and Replacement Table for Mechanical Feeder............................................8-8
8-2-1. Overall Drawing ................................................................................................................... 8-8
8-2.2. Replacing the Drive Cylinder................................................................................................ 8-9
8-2-3. Adjusting the Speed Controller of the Drive Cylinder ......................................................... 8-10
8-2-4. Replacing the Feeder Bank Board (Optional) .................................................................... 8-10
8-2-5. Replacing the Bank PCB ................................................................................................... 8-11
8-3. Replacement Table for Electric Feeder ................................................................8-12
8-3-1. Overall Drawing (Replacement Table for ETF) .................................................................. 8-12
8-3-2. Overall Drawing (Lifter Unit)............................................................................................... 8-14
8-3-3. Replacing the Bank PCB ................................................................................................... 8-15
8-3-4. Replacing the Connector Cable ......................................................................................... 8-16
8-3-5. Replacing the Connector for Off-line Setup ....................................................................... 8-17
8-3-6. Replacing the ETF Incorrect Insertion Detection Sensor ................................................... 8-18
8-4. Electric Fixed Bank (Optional) ..............................................................................8-21
8-4-1. Overall Drawing .................................................................................................................8-21
To Next Page
Loading...
Need help?
General
