JUKI FX-3R - Mounting Switches Onto the Operation Switchboard

FX-3R Maintenance Guide
13-51
13-9-3. Mounting Switches onto the Operation Switchboard
Mount push-button switches such as start switch or stop switch in the sockets on the operation
switchboard as shown below in compliance with the specifications.
1) Configuration
(1) ST front
Rev. 1.00
LEFT FEEDER
RIGHT FEEDER ONLINE
START SERVO FREE
CONSOLE CHANGE
ORIGIN
STOP
CYCLE
EMERGENCY
SW1
SW2
SW7 SW8 SW3 SW5
SW10
SW9 SW4 SW6
[Option]
Figure 13-9-3-1 Operation Switches (ST Front)
Table 13-9-3-1 List of Operation Switch Replacement Parts (ST Front)
No. Switch name Element Actuator LED Bezel Lenz Remarks
SW1
ONLINE HA005340010 HA005340020 HA005340070 HA00534004A HA00552001B
Bezel is provided with a
cover
SW2
ORIGIN HA005340010 HA005340020 HA00534007A HA005520030 HA00552001A
SW3
START HA005340010 HA005340020
―
HA005520030 HA00552001B
SW4
STOP HA005340010 HA005340020
―
HA005520030 HA005520010
SW5
SERVO FREE HA005340010 HA005340020 HA00534007A HA00534004A HA00552001A
Bezel is provided with a
cover
SW6
CYCLE HA005340010 HA005340020 HA005340070 HA005520030 HA00552001B
SW7
LEFT FEEDER “HX00326000A” is assembled.
SW8
RIGHT FEEDER “HX00326000A” is assembled.
SW9
CONSOLE
CHENGE
40048036 HA005530010 HA00553002A
OPTION
(REAR MONITOR)
If the rear motor OP is not
provided, “HX00326000A”
is mounted.
SW10
EMERGENCY 40092833