JUKI FX-3R - Other Boards

FX-3R Maintenance Guide
13-59
13-11. Other Boards
13-11-1. XY-RELAY Board (40047558)
[Functions]
This XY-RELAY board relays the signals coming from the limit sensor and emergency stop
switch of each axis to input them to the position board, etc.
[Jumper switch settings]
 portion shows the switch set position and receptacle mounting position.
Rev. 1.00
Ｏ
SW3
Ｏ
1 2 3 4 5 6 7 8
SW2
Ｏ Ｎ
Ｏ Ｎ
SW 2 [4..1]: Board function Rev.
SW 2 [8..5]: Board pattern Rev.
This switch has been set properly
before shipment from the factory.
Therefore, do not change this
switch setting. The above Figure
shows just an example.
Ｏ
SW3
Ｏ Ｎ
[ST specifications: Setting
before shi
p
ment from factor
y]
[EN specifications]
SW3 to 8 are intended to set the power monitor signal valid or invalid, which
is used only for the machines with the EN specifications. Turn ON these
switches for the machines with the EN specifications.
W
5
1 3
W
6
1 3
W
7
1 3
W
8
1 3
A
ll of other W are opened.
These jumper switches have been set properly
before shipping the board. Therefore, do not change
these jumper switches.
1 2 3 4 5 6 1 2 3 4 5 6 7 8
[Adjustment items after replacement]
There are no particular adjustment items.