JUKI FX-3R - Replacing the ETF Incorrect Insertion Detection Sensor

FX-3R Maintenance Guide
8-18
8-3-6. Replacing the ETF Incorrect Insertion Detection Sensor
1) In the FX-3R, the sensors are arranged as shown in the Figure below.
To remove the sensor together with the bracket, the sensor height needs to be adjusted.
To replace only the sensor, start the work from step 4).
マウンタ上面図
LF
RF
RRLR
REAR
FRONT
LEFT
RIGHT
受投
受投
受 投
受 投
Rec.
Rec.
Rec.
Rec.
Emit Emit
Emit Emit
Top view of mounter
Figure 8-3-6-1 ETF Incorrect Insertion Detection Sensor Layout Drawing
2) Replace the sensor of the bracket assembly you have removed.
Rev. 1.00