To raise the presser foot, raise
the lever on the rear of the
machine until it engages.
-Switch the machine off"O".
-Raise the presser foot.
Press the catch (A) to release the
presser foot from the clamp.
Raise the presser foot lifter to the
highest position and remove the
presser foot sole to the left.
To attach the presser foot sole,
place it under the shaft. The
groove in the shaft should line up
exactly with the presser foot pin.
Lower the shank and the presser
foot will engage automatically.
The handwheel turns
counterclockwise.
Using the machine
Handwheel
Presser foot lifter
Changing the presser foot
A
To Next Page
Loading...
