– 2 –
15mm
9.8N
1
) Assemble the thread stand device. Fit it in the hole in
the table. Tighten locknut
1
so that the thread stand
does not fl uctuate.
2) Fix thread stand bracket
2
on the table with wood
screw
3
.
2. ADJUSTING THE BELT TENSION
WARNING :
To protect against possible personal injury due to abrupt start of the machine, be sure to start the following
work after turning the power off and ascertaining that the motor is at rest.
3. INSTALLING THE THREAD STAND
Adjust the belt tension with the height of the motor so that
the belt sags 15 mm when the center of V belt is applied
with a 9.8N load.
Handwheel
Motor pulley
4. INSTALLING THE KNEE LIFTER
1
3
2
3
2
To Next Page
Loading...
