JUKI SC-922 - 8. Detailed explanation of selection of functions (Part 2)

– 34 –
8
Selection of the optional input/output function (Function setting No. 12)
Select function setting No. 12 with the operating procedure of function set-
ting procedures 1) through 3).
Select the items of "End", "in" and "oUT" with keys
5
and
6
.
[When "in" is selected]
The input function setting connector display number is displayed on indicator
A
. Specify
the display number with key
3
or
4
. Specify the connector pin function corresponding to
the displayed number by means of key
5
or
6
. Function code and abbreviation are dis-
played alternately on indicator
B
. In the case "- - - -" is displayed, the function code and the
abbreviation are automatically determined according to the selected machine head. (Refer
to the appendix for the relation between display numbers and connector pins assignment.)
[When "oUT" is selected]
The output function setting connector display number is displayed on indicator
A
. Specify
the display number with key
3
or
4
. Specify the connector pin function corresponding to
the displayed number by means of key
5
or
6
. Function code and abbreviation are dis-
played alternately on indicator
B
. In the case "- - - -" is displayed, the function code and the
abbreviation are automatically determined according to the selected machine head. (Refer
to the appendix for the relation between display numbers and connector pins assignment.)
* Example) Setting the thread trimming function for the display No. i01 (CN44-4) of the input function setting
connector.
1. Select function setting No. 12 with the operating procedure of function
setting procedures 1) through 3).
2. Select the item of "in" with keys
5
and
6
.
3. Select i01 with key
4
.
4. Select the thread trimming function, "TSW" with keys
5
and
6
.
5. Determine the thread trimming function, "TSW" with key
4
.
6. Set ACTIVE of the signal with keys
5
and
6
.
Set the display to "L" when the signal is "Low" and performing thread
trimming, and set the display to "H" when the signal is "High" and per-
forming thread trimming.
7. Determine the aforementioned function with key
4
.
8. Finish the optional input with key
4
.
9. Select the item of "End" with keys
5
and
6
to return to the function setting mode.
Lighting alternately
6
543
1
2
7
B
A
[\
[\
1 2 TPo _
L 4
H 4
nE d
1 2 TPo _
_ni _
TUo _
TP _ nE_ do
0i 1 ** *
3i 2
0o 1 ** *
3o 2
_ni _
TPo _
0i 1 on P
0i 1 ST W
0i 1
L 4
0i 2 on P
i n
TPo _