Name and Function of each component
■
Stitch length adjusting dial
Stitch length for normal stitching is 2 to 2.5 mm.
(Adjusting range: 0 to 6 mm)
■
Needle up/down switch
Every time the switch is pressed, the needle goes up
or comes down.
This switch can be used when using needle threader
or dropping the needle on the material.
If the switch is continuously pressed, a needle will
move slowly.
Please use when sewing end of fabrics.
■
Reverse feed stitch lever
The seam does not fray when the reverse feed stitching
is performed at the start or the end of sewing.
Mark
10
To Next Page
Loading...
