Winding the bobbin
CAUTION:
Turn OFF the power switch when opening the slide plate.
Installing the thread guide
❶
Raise the support rod fully, turning slightly until the posi-
tioning latches engage.
❷
Set the large spool over the anti vibration cone, or
❸
Set the household-type thread onto the spool pin and then
insert a spool cap in place.
❹
Pass the thread coming from the spool on the thread
guide pin (rod) just above the spool.
❸
❹
❷
❶
Bobbin winder guide
Bobbin thread
winding shaft
Bobbin presser
Positioning latches
1
Take out the bobbin case.
Bring up the needle. Opening the slide plate, take out
the bobbin case.
12
To Next Page
Loading...
