–
1
–
[1] SPECIFICATIONS
(1) Power switch
ON•OFF 2-step changeover switch (common to lamp) located at the belt cover section of the right-hand
side of main unit.
(2) Drive control components
Drive : Built-in motor timing belt method
Control : Foot pedal controller method 50 to 1,500 sti/min
Low speed rotation of 80 sti/min while needle up/down switch is ON
(3) Table, stand and handle components
Main unit : Portable type main unit with soft case (Case is folded in two and packed with main unit.)
One-touch type auxiliary table knee lifter is provided as standard. (Packed together)
Handle : Pull-up/down from machine main unit type
Table/stand: Separately sold fully-sunken type table and stand can be used.
(4) Arm and bed components
Material : Aluminum die casting arm and bed separate body type
Bed form : Flat bed portable type
(5) General mechanism
1. Thread take-up : Slit type link thread take-up for one-touch threading
2. Hook : DB type horizontal full-rotary hook
3. Pressing pressure adjustment : Stepless adjusting screw with pressing pressure indicator method
4. Lighting device : Built in face cover Switch : Slide type Lamp : LED lamp
5. Needle thread post : Two posts for small thread spool and large thread spool
Thread guide of thread post is of draw-out type and capable of
one-touch threading
6. Bobbin thread winder : One-touch action : Starting method by controller Automatic stop when
bobbin thread winding completed
7. Needle thread threading : One-touch threading from thread spool to needle tip
8. Presser foot : Commercially-available presser foot for industrial sewing machine
(SL2) can be used. (Setscrew type)
9. Lift of presser foot : By lever : 7 mm Max. by lever : 12 mm By knee lifter : 12 mm
10. Thread tension : Disk pressure adjusting type with simplied disk pressure scale
11. Drop feed : 2-step changeover by knob method (Feed dog : UP : DOWN)
12. Power switch : ON • OFF 2-step
(6) Feed mechanism
1. Feed amount adjustment : Dial method ...... Stepless 0 to 6 mm
2. Reverse feed stitch : Lever method .... Feed amount conforms to that of normal feed stitch.
To Next Page
Loading...
Need help?
General
