JUKI TSC-441 - Page 32

vi
CAUTION :
Notethatsafetydevicessuchas“eyeguard”,“ngerguard”,etc.maybeomittedfromthe
illustrations in this Instruction Manual for easy explanation.
When operating the machine, be sure not to remove these safety devices.
BEFORE OPERATION
CAUTION :
Check the following so as to prevent maloperation of and damage to the machine.
• Beforeyouputthemachineintooperationforthersttimeaftertheset-up,cleanitthoroughly.
Remove all dust gathering during transportation and oil it well.
• Conrmthatvoltagehasbeencorrectlyset.
 Conrmthatthepowerplughasbeenproperlyconnectedtothepowersupply.
• Never use the machine in the state where the voltage type is different from the designated one.
• Thedirectionofnormalrotationofthemachineiscounterclockwiseasobservedfromthe
pulley side.
Take care not to allow the machine to rotate in the reverse direction.
• Neveroperatethemachineunlessthesewingmachinehavebeenlledwithoil.
• Foratestrun,removethebobbinandtheneedlethread.
• Fortherstmonth,decreasethesewingspeedandrunthesewingmachineataspeedof600
sti/min or less.
• Operatethehandwheelafterthemachinehastotallystopped.