Julabo Corio C - Materials in Contact with Medium; Approved Bath Fluids

Product description
18
5.4.1 Material of parts that come into contact with the medium
The table lists parts that could come into contact with the bath fluid as well as
the material that the parts are made of. This data can be used to check the
compatibility of the parts with the bath fluid used.
Parts that come into contact with the medium Material
Motor
1.4301
Pump PPS
Heating element 1.4404/316L
Inbuilt temperature sensor Pt100 1.4571
Connection of temperature sensor 1.4301
Float 1.4401
Float pipe 1.4571
Hose olive
1.4301
Single-ear clamp 1.4301
Hose FPM/FKM
5.4.2 Bath fluids
Only water with an electrical conductivity of 0.1 to 50 µS is permitted as bath
fluid.
NOTE
No liability accepted for usage of bath fluids that are not
suitable!
Unsuitable bath fluids that are not approved by JULABO can damage the
water bath.
• Use bath fluids that are recommended by JULABO
• Before filling, check the parts that are in contact with the medium for
compatibility with the bath fluid
• Do not exceed the maximum permissible viscosity during operation
• Consult JULABO before using a bath fluid other than the recommended
one