ED
23
Caution:
If the circulator is turned off with the mains switch (1a), the refrigerating
unit is not switched off simultaneously.
Turn off the refrigerating unit with the mains switch (1b) as well.
Danger of freezing when water is used as bath fluid!
6.3. Automatic / non-automatic start mode
Keep depressed enter and
turn on the circulator with the mains power switch.
For a short while the LED temperature DISPLAY indicates the
effective start mode:
AUTOSTART on.
AUTOSTART off.
NOTE:
The circulator has been configured and supplied by JULABO
according to N.A.M.U.R. recommendations. This means for the
start mode, that the unit must enter a safe operating state after
a power failure (non-automatic start mode). This safe operating
state is indicated by „OFF“ on the LED temperature display. A
complete shutdown of the main functional elements such as
heater and circulating pump is effected simultaneously.
Should such a safety standard not be required, the
AUTOSTART function (automatic start mode) may be activated,
thus allowing the start of the circulator directly by pressing the
mains power switch or using a timer.
Warning:
For supervised or unsupervised operation with the AUTOSTART
function, avoid any hazardous situation to persons or property.
The circulator does no longer conform to N.A.M.U.R.
recommendations.
Take care you fully observe the safety and warning functions of the
circulator.
The instrument is not suited for unsupervised continuous operation.
To Next Page
Loading...
