Julabo F32-MA - Page 4

Operating manual
4
8.1.1. Early warning system, low level protection .............................................. 31
8.2. Switch-over from warning to shutdown function ..............................................32
8.3. Over and Sub temperature warning function ...................................................33
9. Menu functions.........................................................................................34
9.1. MENU PUMP – Setting of pump pressure.......................................................35
9.2. MENU Configuration ........................................................................................36
9.2.1. Configuration of the mode of the key ........................................... 37
9.2.2. Remote control: activate – deactivate......................................................37
9.2.3. Automatic / non-automatic start mode .....................................................37
9.2.4. Reset - Factory setting.............................................................................38
9.3. MENU Control parameters – Xp, Tv, Tn ..........................................................38
9.4. MENU SERIAL - BAUDRATE, PARITY, HANDSHAKE ..................................40
9.5. MENU ATC - Absolut Temperature Calibration ...............................................41
9.5.1. ATC STATUS - YES / NO........................................................................43
9.5.2. ATC - TYPE: 1 -/ 2 -/ 3 POINT.................................................................43
9.5.3. Example: 3-point calibration for internal control...................................... 44
9.6. MENU LIMITS ..................................................................................................46
10. Troubleshooting guide / error messages .............................................................47
11. Electrical connections ..........................................................................................50
12. Remote control.....................................................................................................51
12.1. Setup for remote control ..............................................................................51
12.2. Communication with a PC or a superordinated data system.......................51
12.3. List of commands.........................................................................................52
12.4. Status messages .........................................................................................53
12.5. Error messages............................................................................................53
13. JULABO Service – Online remote diagnosis .......................................................55
14. Cleaning / repairing the unit .................................................................................56
15. WARRANTY PROVISIONS .................................................................................57